Introducing the new Seawind 1000XL catamaran, featuring many fantastic new features such as: 850mm Transom Extension, Forward Opening Windows, Self-Tacking Jib, 2:1 Main Halyard, Single Line Reefing, boom cradle and more!
Additional Specs, Equipment and Information:
Hull Shape: Catamaran
LOA: 35 ft 5 in
Beam: 19 ft 5 in
Maximum Draft: 3 ft 3 in
Dry Weight: 12100 lbs
Engine Option 1: 2x 9 HP
Fresh Water Tanks: (105 Gallons)
Fuel Tanks: (26 Gallons)
Dining table: F/G in centre cockpit. Folds down to create double bed.
American Oak used for interiors.
Slides and cabin top lined with frontrunner carpet and vinyl.
Common area - soles timber - teak with holly inlay. Finished in high gloss two pack polyurethane (Estapol) finish ? four coats..
Cabin soles carpet.
Cockpit cushion seats and backrests in Saloon
Solid doors on all private cabins
Mattresses to be 4" foam upholstered
Solid lockable door.Oak/Ash/Cedar exterior finish with waterproof laminex interior finish
PAR manual toilet
Sullage tank built in. Pump out by shore station
Pipes, skin fittings and seacocks to be easily accessible and to meet MSB survey requirements
Vanity basin with pressure fresh water
Fresh water shower with flexible hand-held hose
Electric shower bilge pump with direct overboard discharge
Cupboard/shelves to very high quality
Custom made electrical switch panel with circuit breakers. Very high quality throughout.
Tinned wire used throughout.
3 x heavy duty batteries. BESCO 487 (or equivalent).
230amp heavy duty isolation switch.
Solar Panels: 2 x 120 watt solar panels BP brand (or equivalent).
All cabins with individual lighting.
Galley/saloon area - 2 x fluoro lights.
Diffused lights over aft deck - 2 lights.
Centre cockpit lighting.
Maxie 2 burner LPG stainless steel stove with griller. Flame failure device fitted to shut off LPG immediately in event of flame going out.
2 bowl stainless steel double sink.
Pressure fresh water system.
Whale single tap.
Laminex galley tops, cupboards with perspex sliding front.
Refrigerator with attached separate freezer. 12volt Eutectic system by ICEER.
Drop-down dinette table finished in matching laminex and decorative timber.
Dinette upholstered. Seats 4? foam with backs 2?.
2 x Liferings
2 x Buckets
20m of line
Floating rescue light
Twin Yamaha 10hp engines. Mounted under each helm seat at each steering station.
Remote electric key start.
Dual engine controls at starboard helm station.
Hatches (6 in total)
2 x Forward Hatches Aluminium frame 500 x 500 (Gebo)
2 x Mid cabin hatches. (Gebo)
2 x Aft cabin hatches (Gebo).
4 x Mooring cleats.
1 x Anchor cleats.
Forward catwalk swim ladder - hinges under hinged catwalk.
Ventilation: 2 x Dorade vents (PVC ? Seabird?).
Mast base turning blocks RF 1350.
Saddle at base of mast for halyard attachment.
8 x Rope clutches - Spinlock brand..
Stanchions/Rails: High quality stanchions, bow rails and stern rails with 3 life-lines. 600mm high to meet Australian survey requirements..
4 x access gates with pelican hook releases.
1 x manual bilge pump. (Survey boats have 3 manual pumps).
Mast / Boom / Sails
Mast and boom by Tempo Spars. Mast Tempo Section Anodised clear.
? Double Spreader, 7/8 rig.
? Standing Rigging - Forestay 3/8 (10mm) 1 x 19 wire
- Sidestays 3/8 (10mm) 1 x 19 wire
- Diamonds 5/16 (8mm) 1 x 19 wire.
All fitted with Sealock turnbuckles and end fittings.
? Hinged mast base to allow for lowering on boat.
? Halyards ? 2:1 Main halyard: 10 mm Spectra rope : Heavy duty shackle.
- Jib halyard: 8 mm Spectra rope. Heavy duty shackle.
- Topping lift: 10 mm Double Braid, Heavy duty shackle.
- Spinnaker Halyard: 12 mm Double Braid with snapshackle spliced to end.
? Boom outhaul.
? 2 x mainsail single-line reefing lines fitted and lead back to the cockpit.
? All halyards, reefing lines to be lead back to cockpit through turning blocks, rope clutches
? Sheet Winches: 2 x Harken ST40?s.
? Fully battened mainsail. Luff adjustable batten end caps. Fibreglass sail battens.
? Cruising mainsail cover with integrated lazy jack system.
? Self-tacking headsail traveller track with hardware.
? Tempo mainsail batten sliders.
? Boom cradle will be fitted on the hardtop.
Anchoring / Mooring
Primary anchor system consisting of 35lb CQR type Plough anchor with 30 metres x 8mm short link galvanised chain plus 50 metres x 16mm anchor rope.