2018 Ocqueteau 615 Timonier

Additional Specs, Equipment and Information:

Boat Name
Display Boat

Specs
Builder: Ocqueteau SA
Designer: Ocqueteau
Hull Shape: Planing

Dimensions
LOA: 20 ft 5 in
Beam: 8 ft 0 in
Minimum Draft: 1 ft 0 in
Maximum Draft: 2 ft 4 in
Headroom: 6 ft 0 in
Dry Weight: 1020 kgs

Engines
Cruising Speed: 15 knots
Maximum Speed: 28 knots

Tanks
Fresh Water Tanks: 1 Plastic (25 Litres)
Fuel Tanks: 1 Plastic (30 Litres)

Accommodation
Number of single berths: 1
Number of double berths: 1
Number of cabins: 1
Seating Capacity: 2

Electrical Equipment
Electrical Circuit: 12V

Accommodation

This boat is set up with three berths. Up forward there is a berth than has an infill to make a double. Space below the aft end of the berth for a porta potti and plenty of stowage up forward. Hull shelf on starboard side. 

Up a step to the saloon which has a dinette arrangement to port where the table is removable (goes in the cockpit as well) and an infill cushion forms a generous single berth. 

To starboard there is the helm position with a wooden steering wheel connected to a hydraulic steering system all set up to connect to an outboard motor. 12V panel. Helm seat with fold up bolster and stowage pocket. The helm seat folds forward to reveal the galley which has a moulded sink with a hand pumped water supply from a removable plastic tank. There is a simple single burner removable hob and large storage locker under. 

Access to the cockpit is via a double sliding door. Interior 12V lighting. 

 

Equipment Fitted

• 12v battery setup with switch panel
• Manual and electric bilge pumps
• Wooden steering wheel
• Windscreen wiper
• Port and starboard navigation lights
• Motoring light
• Cockpit cushions in cream vinyl
• Double berth and dinette infill cushions
• Optional port side folding seat in cockpit with cushion
• Two rod holders
• Stainless steel boarding ladder
• Grp cockpit table with leg which fits dinette area as well

Mechanical Systems

The boat can be purchased with or without a motor. The display price is without an engine, however we recommend the following engine options that can be supplied and fitted brand new at these prices with the usual manufacturer warranty:

• Suzuki DF90ATL:  £9,150 including VAT, installation and PDI (max speed 28 knots)

• Suzuki DF115ATL: £10,500 including VAT, installation and PDI (max speed 30 knots +)

Construction

Ocqueteau 615 Timonier built by Ocqueteau SA in 2018. White GRP vacuum infusion moulded hull with grey styling stripe, superstructure and decks with non-slip surfaces. Self draining aft cockpit with good stowage. Steps up to side decks and walk-thru transom 

The clever usage of vacuum infusion allows a superior strength to weight ratio over more traditional construction techniques, resulting in improved efficiency, performance and economy. As a direct result Ocqueteau are able to use smaller engines to achieve the same speeds as many competitors and get surprising performance from their shaft driven range, avoiding the need for more complicated sterndrive options.

Trailer

• A trailer is not included but the used single axle trailer she is sitting on can be purchased for £2,000 inc VAT or we can quote for a new trailer if required.

Disclaimer

The company normally acts as brokers for the vendor who unless otherwise stated is not selling in the course of a business. Whilst every care has been taken in the preparation of these particulars the correctness is not guaranteed and they are intended as a guide only and do not constitute a part of any contract. A prospective buyer is strongly advised to check these particulars and where appropriate and at his own expense to employ a qualified marine surveyor to carry out a survey and/or to have an engine trial conducted which if conducted by us shall not imply any liability on our part.

General note on safety equipment: Any safety equipment such as liferaft, fire extinguishers and flares etc., are usually personal to the current owner(s) and if being left on board as part of the sale of a used vessel, may require routine servicing, replacement, or changing to meet a new owner’s specific needs.